Yunnan cut flower factory: 1 tonne/hour reverse osmosis project

1 tonne/hour RO unit with three pretreatment stages. AI-retouched cover. Original site photos inside.

Yunnan cut flower factory: 1 tonne/hour reverse osmosis project

The equipment images are AI-retouched site photos. Check labels, instrument readings and the exact configuration on the equipment itself.

Equipment and site photos

Gudian Water’s reverse osmosis (RO) project at a cut flower factory in Yunnan uses a unit specified at 1 tonne of treated water per hour (about 1 m³/h). The front view shows the quartz sand and activated carbon vessels, cartridge filter, control cabinet, pressure gauges and flow meters. The site photos also show water storage containers, pipework and the cut flower handling area.

Filtration and controls close-up · AI retouched

Filtration and controls close-up · AI retouched

RO unit and tanks on site · AI retouched

RO unit and tanks on site · AI retouched

How do you size a system for cut flowers?

Start with the water source and peak demand. For postharvest hydration or mixing flower food, check the feedwater pH, alkalinity, hardness and electrical conductivity (EC) or total dissolved solids (TDS). Check water use per shift, periods of concentrated demand and existing storage capacity. RO uses pressure to move water through a membrane and reduce dissolved salts. Actual output varies with feedwater and operating conditions.

The 1 tonne/hour figure is the equipment specification for this project. The photos do not establish sustained flow, treated water quality or comparative flower shelf life. Preservation also depends on the flower variety, temperature, container hygiene and how the solution is mixed.

Cut flower carts near an elevated water tank

Cut flower carts near an elevated water tank

Work aisle with rows of cut flowers awaiting handling

Work aisle with rows of cut flowers awaiting handling

Elevated tanks and pipework along the work area

Elevated tanks and pipework along the work area

Handling containers and flower carts in the cut flower work area

Handling containers and flower carts in the cut flower work area

Technical references and equipment selection

Cut flower water and RO selection guide · Reverse osmosis equipment selection · Contact the technical team

← Project case studies
Contact and request a quote

Equipment and consumables inquiry

For equipment selection, consumable models or maintenance needs, please share the project location, intended use and available information.

Discuss your water treatment requirements ↗